BarCode Inputs

Anything related to Barcode ActiveX programming

BarCode Inputs

Postby atifmushtaq(legacy member) on Mon Mar 24, 2008 11:30 pm

Hello,

Sir,

I have check your barcode activeX this is good but I have Problem in it, that is when I Attech it to database and give "Message" below the Barcode then that is not match with the BarCode Reading, Plaese tell me that how can I set its Complete Value as I like,


Hope you will reply soon,

Thanks,

Atif Mushtaq
System Administrator,
CFR Foundation Pakistan,
37/H Club Road Vehari Pakistan,
Phone #: 0092-300-772-2586
atifmushtaq(legacy member)
 

Re: BarCode Inputs

Postby glitch (legacy member) on Tue Mar 25, 2008 11:30 am

We need more information, such as symbology type and message value. If you do not want to post here, send them to support@morovia.com with screenshots.
glitch (legacy member)
 

Re: BarCode Inputs

Postby atifmushtaq(legacy member) on Wed Mar 26, 2008 2:00 pm

Thanks for reply

sir,

I use symbology type "Code-128" and message "1".
atifmushtaq(legacy member)
 

Re: BarCode Inputs

Postby glitch (legacy member) on Thu Mar 27, 2008 9:26 am

Most bar code scanners require a minimum code length - 4 characters or more. This is because the misread rate increases dramatically when there are less than 4 characters encoded in the barcode.
EitherIncrease the length of input or read the scanner manual to find out how to reduce the minimum code length requirement.
glitch (legacy member)
 


Return to Barcode ActiveX Control

Who is online

Users browsing this forum: No registered users and 2 guests